Getting a good part off a printer is three problems, not one. Each module owns one stage, and hands its work to the next.
Studies your model before you print, flags the geometry, supports and settings most likely to fail, and keeps watch while the build is running.
The front of the pipeline. Turning drawings, photographs and legacy paper geometry into clean CAD and a printable 3D model.
Everything after the build. Qualifying the finished part against the spec it was made to, catching the defects that should never reach a customer, and issuing the certificate that lets it ship.
We are taking on a small number of pilot partners. You get the full platform at founding partner rates, and a direct say in where it goes next.
First access to every new capability, ahead of general release, across all three modules.
Between 80 and 90 percent off standard pricing, held for the whole of your pilot term.
Talk to the people writing the code rather than a support queue, for as long as the pilot runs.
Your requirements steer what we build next. That is the part we cannot get from anywhere else.
Places are limited and taken in small cohorts, so every pilot partner gets real attention rather than a seat in a crowd.
